The Mount Scope Controls group box contains button controls that you can use to move the mount in real time..

NW,N,NE

W, E

SW, S, SE

While pressing one of these buttons the driver will move the mount in that direction at the Move Rate selected.

When the button is released the move will stop.

Note:  the directions (N=North, S=South, etc.) do not necessarily reflect actual compass directions. In some cases North may be swapped with South and East with West.

STOP

Pressing this button will send a command to the mount to immediately stop movement. This includes stopping a slew or park operation.

Swap E/W

Swaps the direction that the mount will move for East/West moves.

Note: if you perform this operation and you are using an autoguider you may need to recalibrate.

The checkbox to the left of Swap E/W

Flips the positions of the NE/E/SE and NW/W/SW buttons.

Swap N/S

Swaps the direction that the mount will move for North/South moves.

Note: if you perform this operation and you are using an autoguider you may need to recalibrate.

The checkbox to the left of Swap N/S

Flips the positions of the NW/N/NE and SW/S/SE buttons.

Rotate 90

Rotates the position of the direction buttons by 90 degrees.

MoveScope

 

Astro-Physics AP V2 Driver v5.60.xx