You can use the simple two-step procedure in this page to resynchronize your mount to your Software Bisque TPoint model if you accidentally move your scope by hand.
First, if you moved your scope by hand, try to reorient it to where it should be or do an unpark from one of the AP park positions. Then connect in TheSky and slew to a reasonably bright star. If the TPoint model is synched properly to the mount then the star will be near the center of the field (using a CCD camera is recommended).
If the star is not centered then press the Get RA/DEC button. PulseGuide will get the current coordinates from the mount then display them in the RA and DEC read-only edit boxes. This will also enable the Reset RA/DEC button as shown in the next figure.
Now using the buttons, or manually moving the scope, center the star that you previously slewed to in the last step. This of course may change the RA/DEC of the mount but when you press the Reset RA/DEC button the mount is then sent updated the coordinates (coordinates that TPoint issued to bring the star to the center).
If a long period of time elapses between steps 1 and 2, you may need to repeat the procedure.